A voltmeter was used to check the coolant and a reading of 0.2 volt with the engine off was measured. A reading of 0.8 volt was measured with the engine running and all electrical accessories turned on. Technician A says that the coolant should be flushed to solve the galvanic activity. Technician B says that the ground wires and connections should be inspected and repaired to solve the electrolysis problem. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Question 2
What tool should be used to loosen or tighten brake or fuel lines?
A) Locking pliers B) Line wrench
C) Torque wrench D) Multigroove adjustable pliers
A turbocharged Ford three-cylinder 1.0 liter Eco Boost engine.
After the engine has been cranked for four “puffs,” stop cranking the engine and observe the ...
After adjusting the valves that are closed, rotate the engine one full rotation until the engine ...
The IAT sensor on this General Motors 3800 V-6 engine is in the air passage duct between the air ...
Start the vehicle’s engine and let run at 1000–1500 RPM. The engine is now running on fuel ...
Fingertip kneading along the paraspinal muscles from shoulders to buttocks. Check to make sure all ...