« previous next »

Author Question: When troubleshooting, why would you perform voltage and resistance checks? A. To check for ... (Read 22 times)

Jipu 123

  • Hero Member
  • *****
  • Posts: 569
on: Jul 28, 2018
When troubleshooting, why would you perform voltage and resistance checks?
 
  A. To check for signals
  B. To eliminate induced failures
  C. To observe frequency spectra
  D. To isolate defective components

Question 2

What agency in the United States has been given the authority to establish and enforce regulations regarding the use of radio transmitters and other generators of radio-frequency energy?
 
  A. Transport and Communications Ministry
  B. Federal Communications Commission (FCC)
  C. International Telecommunication Union (ITU)
  D. Bell Laboratories


ebenov

  • Sr. Member
  • ****
  • Posts: 331
Reply #1 on: Jul 28, 2018
Answer to Question 1

D

Answer to Question 2

B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Only 12 hours after an egg cell is fertilized by a sperm cell, the egg cell starts to divide. As it continues to divide, it moves along the fallopian tube toward the uterus at about 1 inch per day.

Did you know?

The Centers for Disease Control and Prevention has released reports detailing the deaths of infants (younger than 1 year of age) who died after being given cold and cough medications. This underscores the importance of educating parents that children younger than 2 years of age should never be given over-the-counter cold and cough medications without consulting their physicians.

Did you know?

On average, the stomach produces 2 L of hydrochloric acid per day.

Did you know?

Symptoms of kidney problems include a loss of appetite, back pain (which may be sudden and intense), chills, abdominal pain, fluid retention, nausea, the urge to urinate, vomiting, and fever.

Did you know?

Ether was used widely for surgeries but became less popular because of its flammability and its tendency to cause vomiting. In England, it was quickly replaced by chloroform, but this agent caused many deaths and lost popularity.

Drug Resistance Drug Resistance
A potentiometer uses a movable contact to vary resistance and send an analog voltage to the PCM. A potentiometer uses a movable contact to vary resistance and send an analog voltage to the PCM.
When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ... When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ...
Walk around the head of the table to the left side and reach across to perform threecount stroking ... Walk around the head of the table to the left side and reach across to perform threecount stroking ...
How much voltage does the resistor drop in Figure 10-2? How much voltage does the resistor drop in Figure 10-2?
Use the Henderson-Hasselbalch equation to perform the following calculations. Use the Henderson-Hasselbalch equation to perform the following calculations.
Video: What is Cholesterols? Introduction to Lipoproteins

For a complete list of videos, visit our video library