Skills and Trades

A typical Chrysler immobilizer system is called ________. A) Passlock B) SKIS C) VATS D) ...

Started by awywial

Type B misfire codes are set if the misfire exceeds ________ to ________, depending on the engine, ...

Started by lbcchick

A technician attaches one lead of a digital voltmeter to the ground terminal of the TP sensor and ...

Started by Marty

Mode 06 information can be accessed at ________. A) http://service.gm.com B) http://www.nastf.org ...

Started by jeatrice

Technician A says Chrysler OBD-I (1981-1995 ) vehicles were equipped with a BUS system called Serial ...

Started by OSWALD

The computer will automatically clear a DTC if there are no additional detected faults after ...

Started by wenmo

OBD-II requires the PCM to detect faults allowing emissions that exceed how many times the FTP ...

Started by Alainaaa8

Which OBD-II term describes the check engine light? A) CARB B) CEL C) MIL D) ...

Started by RRMR

Mode 06 can be used to verify a repair by checking ________. A) Sensor values B) DTCs C) A ...

Started by robinn137

Technician A says that by looking at the mode 06 data, the technician can determine how close a ...

Started by gonzo233

Which of these is a single-wire serial communications protocol, using one master control module and ...

Started by yoooooman

Technician A says a CANDi module will flash the RED LED rapidly if communication is detected. ...

Started by Garrulous

Technician A says that some scan tools translate the raw hexadecimal data into English, using ...

Started by natalie2426