Skills and Trades

Component location can be found in _______. A) Factory service manuals B) Owners manuals C) ...

Started by biggirl4568

Research shows that owner's range anxiety fades after about ________ of driving. A) Two weeks B) ...

Started by littleanan

What test is being performed in this illustration (engine running)? A) Diode test B) Alternator ...

Started by burton19126

The brake pedal assembly uses a mechanical lever to ________. A) Increase the driver's force on ...

Started by kfurse

Technician A says that charging system testing requires that the battery be at least 75 charged. ...

Started by luvbio

Technician A says that a dry chemical fire extinguisher can be used on class A, B, and C fires. ...

Started by gonzo233

Used engine oil should be disposed of by any of the following methods EXCEPT ________. A) Burned ...

Started by nenivikky

Technician A says low oil pressure causes engine wear. Technician B says engine wear can cause low ...

Started by MGLQZ

Technician A says that all orifice tubes on all vehicles use the same size orifice size. Technician ...

Started by roselinechinyere27m

Technician A says that the secondary air injection (SAI) system forces air at low pressure into the ...

Started by armygirl

Hotline services are _______. A) Accessed by the internet B) Available for a service fee C) Free ...

Started by Sufayan.ah

As additional branches are added to a a parallel circuit, total circuit resistance _______. A) ...

Started by theo

Wiring schematics have which information about circuits? A) Wire size B) Circuit number C) Wire ...

Started by MGLQZ

Design requirements for vehicle brakes include ________. A) Fluid that does not freeze B) ...

Started by stevenposner

Before returning the vehicle to the customer the new brake pads should be _______. A) Burned B) ...

Started by madam-professor

Rotors are more likely to become scored than drums. Indicate whether the statement is true or ...

Started by codyclark

Engine blocks can be manufactured using which of these methods? A) Sand cast or die-cast B) ...

Started by nelaaney

The proper method to operate a torque wrench is to: a. use two hands to pull it b. pull the grip ...

Started by ss2343

Cracks, unless they extend over the entire surface of the drum or rotor, can be ignored. Indicate ...

Started by rl

Typically, a vehicle height sensor mounts to the body of the vehicle and is connected to the ...

Started by hbsimmons88

Which is true of biodiesel fuel? A) Reduces hydrocarbon emissions B) Reduces particulate matter ...

Started by sam.t96

In what year did PCV system monitoring become mandatory? A) 1996 B) 2004 C) 1988 D) ...

Started by washai

Where is the force of magnetic lines strongest in a bar magnet? A) In the middle of the magnet B) ...

Started by armygirl

If a vehicle computer fails, what should the technician do before replacing the computer? A) ...

Started by jessicacav

All OBDII vehicles use what type of read-only memory? A) EEPROM B) EPROM C) PROM D) ...

Started by Chelseaamend