Technician A says that by looking at the mode 06 data, the ...

[gonzo233]

Technician A says that by looking at the mode 06 data, the technician can determine how close a component or system came to passing the onboard test. Technician B says that the data shown may have to be converted to obtain values that are meaningful to the technician. Which technician is correct?
 
  A) Technician A only B) Technician B only
  C) Both technicians D) Neither technician

Question 2

A DMM set to read DC volts is connected across terminals 6 and 14 of the DLC. The meter reads zero volts at all times, key on or key off. This indicates ________.
 
  A) A CAN BUS shorted to ground B) A low temperature condition
  C) Bad UART output D) Headlights are OFF

[DylanD1323]

Answer to Question 1

B

Answer to Question 2

A