Technology

Parallel lines in space will appear as perpendicular lines in the right-side view. Indicate ...

Started by lidoalex

When showing a blind drilled hole (a hole ending within the feature), it is customary to show the ...

Started by leo leo

A vertice is a common intersection of three or more surfaces. Indicate whether the statement is ...

Started by 2125004343

A miter line may be used to transfer measurements between the top and right-side view. Indicate ...

Started by Frost2351

Reverse construction refers to the technique of creating the auxiliary view first and then ...

Started by mydiamond

With the development of 3-D CAD, the need for prototypes has been nearly eliminated. Indicate ...

Started by folubunmi

Methods used to process materials to the desired shapes can adversely affect the product's final ...

Started by LaDunn

To reduce cost of handling materials, designing components for automated and ____________ assembly ...

Started by jCorn1234

Which line is thin, dark, and has arrowheads on each end? a. Section lines b. Extension lines ...

Started by aabwk4

Often, with good planning, rapid prototyping can be accomplished using the _______________ design ...

Started by ericka1

Which of the following is preferred by ANSI? a. Slopes on machine parts are indicated radio ...

Started by Evvie72

Good dimensioning practice requires the student to: a. Learn correct technique b. Learn the ...

Started by laurencescou

Every feature must have two dimensions applied or understood. One is the size dimension, and the ...

Started by Bob-Dole

Except in special cases, the dimension line meets the extension lines at ________________ angles. ...

Started by bcretired

Double dimensioning is the process of placing dimensions in standard inches and millimeters. ...

Started by SGallaher96

The section view that does not use a cutting plane line and is limited by a break line is called a ...

Started by jrubin

The relationship of the tolerance to the basic size is referred to as the _______________________. ...

Started by stephzh

A cutting plane line that is not straight and is offset or bending through the object is typically ...

Started by CharlieWard

Which line type may be used to show a repetition of a series of identical features? a. Object ...

Started by jjjetplane

The jam nut is a special nut to allow easy unscrewing. Indicate whether the statement is true or ...

Started by theo

The design process in which components are sized and then final assembly is built around the design ...

Started by Garrulous

Drawings that show how several parts fit together are commonly called ________________ drawings. ...

Started by Charlie

A key is used to prevent relative movement between a shaft and wheel. Indicate whether the ...

Started by waynest

The screw identified as .75x2.50 HEX CAP SCR is 2 inches long. Indicate whether the statement is ...

Started by nautica902

Even with extensive network drives, backups are essential. Indicate whether the statement is true ...

Started by eruditmonkey@yahoo.com