Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
In 2013, Americans learned that the federal government massively surveys their phone calls and e-mai
A schematic of a typical glow plug circuit. Notice that the relay for the glow plug and intake air ...
Altitude affects the MAP sensor voltage.
A planar design zirconia oxygen sensor places all of the elements together, which allows the sensor ...
Using a digital multimeter to test an oxygen sensor using the MIN/MAX record function of the meter.
Connecting a handheld digital storage oscilloscope to an oxygen sensor signal wire. The use of the ...