Skills and Trades

The higher the transmitting voltage the more difficult it is to safely insulate the line wires.

Started by Scollins7

With a 240 V source, voltage is divided across three series resistors of 30 V, 40 V, and:

Started by C0DxHalo

If the applied voltage to a series circuit doubles the resistance will double.

Started by isam

Kirchhoff's voltage law states:

Started by wqwpfwpoefnpwenf

When one of the two line fuses of a three-wire system blows, it is possible to have voltages that no ...

Started by Labomba

An ideal voltage source supplies any amount of current with no change in its:

Started by meganh99

An ideal voltage source supplies any amount of current with no change in its:

Started by shanell

The current flow through and the voltage across RL, for the circuit drawn below would be

Started by xxxxxxxxxxxx

The Norton resistance and current, as viewed by RL, for the circuit shown would be:

Started by lingual

The Thevenin resistance and voltage, as viewed by RL, for the circuit shown would be:

Started by ddddddddddeeee4444

Any load resistor connected between the terminals of a Thevenin equivalent circuit will have the ...

Started by redpassion

Both the Thevenin and Norton theorems can be used with either single-source or multiple-source circuits.

Started by Lin Shi

In solving a complex circuit, a negative value of current indicates that a calculation error was made.

Started by C0DxHalo

Norton's theorem is used for simplifying a network in terms of currents instead of voltages.

Started by abcdef9106

Norton's theorem is used for simplifying a network in terms of currents instead of voltages.

Started by effaey

Norton's theorem reduces a resistive network to an ideal current source in parallel with resistance.

Started by hjfhdiskkjs

Ohm's law does not apply when you are using the superposition method of circuit analysis.

Started by warrenjean01

When applying the superposition theorem to a circuit, in order to zero a current source, we replace ...

Started by moore.cailinf

When applying the superposition theorem, the direction of the resultant current for two currents ...

Started by blinding37

________ is an abbreviation for RMS.

Started by Adc3669

________ is the output of an AC generator measured in cycles per second.

Started by llesku

________ would be equivalent term for cycles per second.

Started by frosh101

A(n) ________ is a number of conductive wires, wound in loops, which rotate through a magnetic field.

Started by joe3899

Most commercial and industrial installations require ________ distribution systems.

Started by unreallynx

The effects of Eddy Currents and Skin Effect in AC circuits act to

Started by isam