This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which of these sensors could be used to check for a poor PCM ground? A) ECT sensor B) IAT sensor ... (Read 397 times)

sammy

  • Hero Member
  • *****
  • Posts: 818
on: Jun 22, 2018
Which of these sensors could be used to check for a poor PCM ground?
 
  A) ECT sensor B) IAT sensor
  C) Oxygen (O2S) Sensor D) TP sensor

Question 2

Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?
 
  A) Technician A only B) Technician B only
  C) Both technicians D) Neither technician


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

joneynes

  • Sr. Member
  • ****
  • Posts: 376
Reply #1 on: Jun 22, 2018
Answer to Question 1

D

Answer to Question 2

B


sammy

  • Member
  • Posts: 818
Reply 2 on: Jun 22, 2018
Gracias!

coreycathey

  • Member
  • Posts: 333
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

Despite claims by manufacturers, the supplement known as Ginkgo biloba was shown in a study of more than 3,000 participants to be ineffective in reducing development of dementia and Alzheimer’s disease in older people.

Did you know?

Excessive alcohol use costs the country approximately $235 billion every year.

Did you know?

Common abbreviations that cause medication errors include U (unit), mg (milligram), QD (every day), SC (subcutaneous), TIW (three times per week), D/C (discharge or discontinue), HS (at bedtime or "hours of sleep"), cc (cubic centimeters), and AU (each ear).

Did you know?

A good example of polar molecules can be understood when trying to make a cake. If water and oil are required, they will not mix together. If you put them into a measuring cup, the oil will rise to the top while the water remains on the bottom.

Did you know?

The average person is easily confused by the terms pharmaceutics and pharmacology, thinking they are one and the same. Whereas pharmaceutics is the science of preparing and dispensing drugs (otherwise known as the science of pharmacy), pharmacology is the study of medications.

Sixteen-pin OBD II DLC with terminals identified. Scan tools use the power pin (16) ground pin (4) ... Sixteen-pin OBD II DLC with terminals identified. Scan tools use the power pin (16) ground pin (4) ...
An ECT sensor being tested using a digital meter set to DC volts. A chart showing the voltage ... An ECT sensor being tested using a digital meter set to DC volts. A chart showing the voltage ...
A typical temperature sensor circuit. A typical temperature sensor circuit.
A backpressure tool can be made by using an oxygen sensor housing and using epoxy or braze to hold ... A backpressure tool can be made by using an oxygen sensor housing and using epoxy or braze to hold ...
Prepare upper back for hot application. Undrape upper back. Check tissues visually and through ... Prepare upper back for hot application. Undrape upper back. Check tissues visually and through ...
Check heat source for temperature. Evaluate the amount of heat given off from the source using your ... Check heat source for temperature. Evaluate the amount of heat given off from the source using your ...
Video: Oxygen - hemoglobin dissociation curve & Hemoglobin's affinity with oxygen - acidity

For a complete list of videos, visit our video library