Skills and Trades

In general, the first step when preparing for shutdown and repair is to ________. A) secure all ...

Started by dejastew

Skills USA sponsors: A) HVACR industry trade publications. B) Financially challenged students ...

Started by WhattoUnderstand

Many national and international trade associations have trade shows primarily to: A) Use them as ...

Started by Davideckstein7

All NATE specialties are offered at two levels. They are: A) Journeyman and master. B) Heating ...

Started by tichca

Select the NATE specialty test areas. (You may select more than one.) A) Air distribution B) ...

Started by gonzo233

Who is the ICE exam designed for? A) Any HVACR service technician B) Technicians working on ice ...

Started by KWilfred

What benefit is there to the student in taking the ICE exam? A) Enhanced job opportunity B) ...

Started by naturalchemist

Electro-hydraulic actuators/operators must be installed in a(n) ________. A) underwater location ...

Started by xclash

The base of an extension ladder that is correctly set up will be: A) 1 foot from the wall for ...

Started by chads108

Federal law applies to pipeline maintenance activities that ________. A) involve bench work ...

Started by beccaep

Factors to consider when selecting lubricants include climate, exposure of the component, ________, ...

Started by naturalchemist

To move the grease into the fitting, a grease gun uses ________. A) a heater to melt and apply ...

Started by scienceeasy

If the nameplate of an electric valve actuator/operator is missing, replace it according to ...

Started by dakota nelson

Select safe shop practices. (You may select more than one.) A) Store oily shop towels in metal ...

Started by Metfan725

It may be necessary to use a map along with ________ to locate valves if they are in open terrain. ...

Started by rlane42

Paint is a strong defense against ________. A) third-party damage B) product leakage C) ...

Started by michelleunicorn

Some actuator/operator malfunctions may need to be referred to ________ technicians. A) RTU B) ...

Started by Melani1276

When reinstalling the worm gear assembly, the blanking plug must be ________ into place. A) ...

Started by javeds

Electric actuators/operators on quarter-turn valves are designed with a(n) ________ gear. A) ...

Started by Cooldude101

Acetylene should never be used: A) Above 15 psi. B) Below 20 psi. C) Above 20 psi. D) Below 15 ...

Started by geoffrey

When adjusting limit and torque switches, special precautions must be taken because the procedures ...

Started by xclash

If an electric actuator/operator motor fails, it must be ________. A) replaced B) documented C) ...

Started by kamilo84

Some stem nuts may need to be replaced because ________. A) vibration has caused them to fall out ...

Started by berenicecastro

In general, when adjusting an actuator/operator, the first step is to verify ________. A) its ...

Started by azncindy619

Maintenance tasks on meters and provers should be divided according to the ________. A) ...

Started by lilldybug07