Skills and Trades

What is the function of compression rings?

Started by segrsyd

How is a long block different from a short block?

Started by Engineer

Describe a basic short block assembly.

Started by Cooldude101

Using cleaning ovens is a more environmentally acceptable process than chemical cleaning.

Started by jc611

The timing belt cover should be removed before the water pump.

Started by madam-professor

The engine in a FWD vehicle is usually removed through the hood.

Started by Zulu123

It is a good practice to discard all engine gaskets immediately so they do not accidentally get reused.

Started by chads108

An electric cooling fan assembly and radiator cannot be removed together.

Started by dmcintosh

When removing the cylinder head, keep ________________________ in exact order.

Started by cartlidgeashley

The engine should be ________________________ in the middle of the engine stand's adapter plate.

Started by nramada

Sling attaching bolts must be large enough to support the engine and thread into the block at a ...

Started by panfilo

It is important to let an aluminum cylinder head ________________________ before removing it.

Started by joblessjake

A thermal cleaning oven reaches a temperature of ________________________C ________________________F).

Started by armygirl

Why should fasteners be organized during removal?

Started by lracut11

Which statement best describes water-based cleaning solutions?

Started by sabina

Which procedure is recommended before mounting the engine onto an engine stand?

Started by Diane

Which of the following would cause a buildup of sludge inside an engine?

Started by jace

Which material should NOT be cleaned with caustic soda?

Started by Davideckstein7

What type of parts cleaning requires additional shot blasting or washing?

Started by acc299

What is the minimum number of bolts required to safely mount an engine on a stand?

Started by joe

What drivetrain layout most often involves removing the engine from the bottom of the vehicle?

Started by nautica902

In which order should cylinder head bolts be removed?

Started by geoffrey

A technician is inspecting an aluminum cylinder head for cracks. What method of crack detection ...

Started by penza

When removing a transmission with the engine in most RWD vehicles, what can ease the process?

Started by bb

What precautions should be taken when cleaning an engine prior to its removal?

Started by appyboo