Technology

Which of the following enables you to control the behavior of very specific areas on the surfaces of ...

Started by chandani

Suppose that when using the SLICE command, you define the imaginary slicing plane as parallel to the ...

Started by Marty

The REVOLVE command can create a 3D solid of revolution by turning a closed planar object around any ...

Started by darbym82

The THICKEN command converts surfaces and regions into 3D solids by thickening them. Indicate ...

Started by formula1

When more than one object is swept and a base point is not specified, its default location with ...

Started by waynest

The INTERFERE command can use either one or two sets of 3D solids to find the interferences existing ...

Started by EAugust

The tools of the SOLIDEDIT command will not allow you to change the color of which of the following ...

Started by laurencescou

Inside the SOLIDEDIT command, you can apply the same methods to select faces of a 3D solid as those ...

Started by nautica902

The imaginary slicing plane is the plane with which a 3D solid or group of 3D solids is cut through ...

Started by dmcintosh

The Clean tool removes only the temporary imprinted edges that do not split any of the 3D solid's ...

Started by genevieve1028

Right-clicking on a paper space tab exposes a shortcut menu. Which of the following is not part of ...

Started by rayancarla1

A 3D solid object can be sliced only by an imaginary plane. Indicate whether the statement is ...

Started by jasdeep_brar

Placing dimensions on top of a 3D object is a practical way of providing technical information. What ...

Started by dmcintosh

Which of the following views cannot be created with the SOLVIEW command after a first viewport is ...

Started by tsand2

When used in paper space, layers have an additional function: You can freeze them in each viewport ...

Started by c0205847

You can achieve similar results by either adding a jog to an existing section object or using the ...

Started by ec501234

With the SOLPROF command, you can only obtain the projections of orthographic and isometric views. ...

Started by TFauchery

In which of the following cases can you not create a rendered image from the 3D model? a. The 3D ...

Started by asan beg

Which of the following can be used to attach a material to a 3D object? a. Layers b. Properties ...

Started by serike

Any of the three lights (direct, spot, and point) can be directly selected by picking its glyph. ...

Started by jake

To use a material that you have created in a previous drawing, you can use the Tool Palettes as the ...

Started by crazycityslicker

After activating the 3D Orbit tool, you can switch to the Walk 3D navigation mode by pressing the ...

Started by mikaylakyoung

Which of the following cannot be used as a render procedure in the Advanced Render Settings palette? ...

Started by V@ndy87

To create exploded assembly drawings, you must use special tools and settings exclusively dedicated ...

Started by michelleunicorn

For which of the following types of lights must you define both a location and a direction? a. ...

Started by lidoalex