Physics

Assume re = 15 . Refer to Figure 1. Assume that Cbc = 6 pF and RL= 27 k. The Miller input ...

Started by haleyc112

Assume re = 15 . Refer to Figure 1. What value of RL will produce a cutoff frequency due to ...

Started by kwoodring

Assume re = 15 . Refer to Figure 1. The cutoff frequency due to C1 is

Started by Starlight

Assume re = 15 . Refer to Figure 1. Rin is approximately

Started by ARLKQ

The critical frequency of an amplifier is specified at a power gain of

Started by jCorn1234

If a voltage gain of an amplifier is halved it represents a drop of

Started by casperchen82

The parasitic base-collector capacitance of a CE or CS amplifier affects

Started by humphriesbr@me.com

A step-response measurement can be used to test either the high- or the low-frequency response of an ...

Started by appyboo

At the midrange frequency of an inverting amplifier, the phase shift is 180.

Started by xclash

The phase shift at the upper cutoff frequency of an amplifier is 90.

Started by penguins

If Vout at the lower cutoff frequency is 1.0 V, the midrange output is 0.707 V.

Started by maychende

A Bode plot is a graph of decibel voltage gain as a function of phase angle.

Started by geoffrey

A voltage gain of 20 dB represents a voltage gain of 10.

Started by fox

The Miller effect lowers the high-frequency response of inverting amplifiers.

Started by ahriuashd

The input coupling capacitor affects the low-frequency response.

Started by mpobi80

Compared to a mechanical relay, a solid-state relay

Started by kamilo84

Refer to Figure 7. The logic circuit represented is a

Started by kodithompson

Refer to Figure 7. If both VA and VB are low (0), then both

Started by RODY.ELKHALIL

E-MOSFETs are excellent for logic switching because of their

Started by ereecah

Switched capacitors are used to emulate a

Started by asd123

When a PWM signal is reconstructed, the purpose of the low-pass filter is to remove

Started by cartlidgeashley

In order to sample a waveform that is later reconstructed, the minimum sampling rate must be equal to

Started by cdr_15

In pulse width modulation, the output pulses are proportional to the

Started by skymedlock

Refer to Figure 6. This circuit is an example of

Started by appyboo

Refer to Figure 5. This circuit is an example of a

Started by jparksx