This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Before checking the switches in the circuit to a non-functioning load, the technician should first ... (Read 76 times)

ap345

  • Hero Member
  • *****
  • Posts: 537
on: Jul 27, 2018
Before checking the switches in the circuit to a non-functioning load, the technician should first check:
 
  A) The resistance of all the devices in the same circuit with the non-functioning device.
  B) Line voltage, control voltage, and voltage to the non-functional component.
  C) The current draw of the nonfunctioning device.
  D) The resistance of the nonfunctioning device.

Question 2

When troubleshooting an induced draft gas furnace, what should be checked if the induced draft fan comes on but the igniter is never energized?
 
  A) Check the control transformer.
  B) Check the microamp signal of the flame sensor.
  C) Check the incoming gas pressure.
  D) Check the draft pressure switch to see if it is closed.


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

aburgess

  • Sr. Member
  • ****
  • Posts: 361
Reply #1 on: Jul 27, 2018
Answer to Question 1

B

Answer to Question 2

D


ap345

  • Hero Member
  • *****
  • Posts: 537
Reply #2 on: Jul 27, 2018
Thank you!


aburgess

  • Sr. Member
  • ****
  • Posts: 361
Reply #3 on: Jul 27, 2018
Always glad to help...


« previous next »
 

Did you know?

When intravenous medications are involved in adverse drug events, their harmful effects may occur more rapidly, and be more severe than errors with oral medications. This is due to the direct administration into the bloodstream.

Did you know?

Over time, chronic hepatitis B virus and hepatitis C virus infections can progress to advanced liver disease, liver failure, and hepatocellular carcinoma. Unlike other forms, more than 80% of hepatitis C infections become chronic and lead to liver disease. When combined with hepatitis B, hepatitis C now accounts for 75% percent of all cases of liver disease around the world. Liver failure caused by hepatitis C is now leading cause of liver transplants in the United States.

Did you know?

Approximately one in three babies in the United States is now delivered by cesarean section. The number of cesarean sections in the United States has risen 46% since 1996.

Did you know?

As of mid-2016, 18.2 million people were receiving advanced retroviral therapy (ART) worldwide. This represents between 43–50% of the 34–39.8 million people living with HIV.

Did you know?

Automated pill dispensing systems have alarms to alert patients when the correct dosing time has arrived. Most systems work with many varieties of medications, so patients who are taking a variety of drugs can still be in control of their dose regimen.

Hall-effect switches use metallic shutters to shunt magnetic lines of force away from a silicon ... Hall-effect switches use metallic shutters to shunt magnetic lines of force away from a silicon ...
A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ... A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ...
A plastic MAP sensor used for training purposes showing the electronic circuit board and electrical ... A plastic MAP sensor used for training purposes showing the electronic circuit board and electrical ...
Field technician in Utah Field technician in Utah
Find the voltage, current and power for each resistor in the circuit below Find the voltage, current and power for each resistor in the circuit below
What is the total resistance of the circuit in Figure 1? 150 What is the total resistance of the circuit in Figure 1? 150
Video: Types of antimicrobial substances (interferons & complement protein)

For a complete list of videos, visit our video library