« previous next »

Author Question: When an edge finder is used to align the spindle center line with a workpiece edge, the spindle RPM ... (Read 44 times)

james

  • Hero Member
  • *****
  • Posts: 573
on: Jul 26, 2018
When an edge finder is used to align the spindle center line with a workpiece edge, the spindle RPM should be:
 
  A) 300 B) 500 C) 700 D) 900

Question 2

A workpiece that is to be clamped to the machine table, can be aligned with the table axis by:
 
  A) Placing it against stops in the T-slots
  B) Indicating the side of the workpiece
  C) Measuring from the edge of the table to the side of the work
  D) All of the above


ntsoane kedibone

  • Sr. Member
  • ****
  • Posts: 333
Reply #1 on: Jul 26, 2018
Answer to Question 1

C

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Addicts to opiates often avoid treatment because they are afraid of withdrawal. Though unpleasant, with proper management, withdrawal is rarely fatal and passes relatively quickly.

Did you know?

After 5 years of being diagnosed with rheumatoid arthritis, one every three patients will no longer be able to work.

Did you know?

It is believed that humans initially contracted crabs from gorillas about 3 million years ago from either sleeping in gorilla nests or eating the apes.

Did you know?

In the United States, there is a birth every 8 seconds, according to the U.S. Census Bureau's Population Clock.

Did you know?

Most strokes are caused when blood clots move to a blood vessel in the brain and block blood flow to that area. Thrombolytic therapy can be used to dissolve the clot quickly. If given within 3 hours of the first stroke symptoms, this therapy can help limit stroke damage and disability.

Statistics Center (07/2016) Statistics Center (07/2016)
Use a vacuum or fuel line hose over the spark plug to install it without danger of cross-threading ... Use a vacuum or fuel line hose over the spark plug to install it without danger of cross-threading ...
The engine is rotated until the timing marks again align indicating that the companion cylinder ... The engine is rotated until the timing marks again align indicating that the companion cylinder ...
The chart under the cover for the relay center indicates the location of the relay that controls ... The chart under the cover for the relay center indicates the location of the relay that controls ...
Tai chi stance with front foot pointing straight ahead and back foot at 45° angle, heels in line, ... Tai chi stance with front foot pointing straight ahead and back foot at 45° angle, heels in line, ...
Offset Method Plot of Land with Length Line Offset Method Plot of Land with Length Line
Video: Interview with an Anorexic Woman (Part 2 of 2)

For a complete list of videos, visit our video library