The crankshaft is supported in the engine block by the ________.
A) Flywheel B) Main bearings C) Thrust plates D) Rod bearings
Question 2
Technician A says primary vibration is created by the slight differences in the inertia of the pistons between top dead center and bottom dead center. Technician B says secondary vibration is a strong low-frequency vibration caused by the movement of the piston traveling up and down in the cylinder. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
A horizontally opposed engine design helps to lower the vehicle’s center of gravity.
A direct injection diesel engine injects the fuel directly into the combustion chamber. Many ...
A typical engine-driven cooling fan.
An intermediate shaft drives the oil pump on this overhead camshaft engine. Note the main gallery ...
An overhead camshaft engine equipped with variable valve timing on both the intake and exhaust ...
The IAT sensor on this General Motors 3800 V-6 engine is in the air passage duct between the air ...