Author Question: Which of the following is the correct RPM for drilling a 1.000 inch diameter hole in SAE 4140 if the ... (Read 79 times)

mikaylakyoung

  • Hero Member
  • *****
  • Posts: 531
Which of the following is the correct RPM for drilling a 1.000 inch diameter hole in SAE 4140 if the CS is 50 SFPM?
 
  A) 25 B) 160 C) 250 D) 1600

Question 2

Which cutting fluid would be be best for reaming or tapping low carbon steel?
 
  A) Kerosene B) Lubricating oil C) Soluble oil D) Sulfurized oil



Brummell1998

  • Sr. Member
  • ****
  • Posts: 324
Answer to Question 1

C

Answer to Question 2

D



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
 

Did you know?

More than 34,000 trademarked medication names and more than 10,000 generic medication names are in use in the United States.

Did you know?

Asthma-like symptoms were first recorded about 3,500 years ago in Egypt. The first manuscript specifically written about asthma was in the year 1190, describing a condition characterized by sudden breathlessness. The treatments listed in this manuscript include chicken soup, herbs, and sexual abstinence.

Did you know?

People with alcoholism are at a much greater risk of malnutrition than are other people and usually exhibit low levels of most vitamins (especially folic acid). This is because alcohol often takes the place of 50% of their daily intake of calories, with little nutritional value contained in it.

Did you know?

Human kidneys will clean about 1 million gallons of blood in an average lifetime.

Did you know?

Sildenafil (Viagra®) has two actions that may be of consequence in patients with heart disease. It can lower the blood pressure, and it can interact with nitrates. It should never be used in patients who are taking nitrates.

For a complete list of videos, visit our video library