A Methods and Measurements Analyst needs to develop a time standard for a certain task. The task involves use of ruler, square, and portable electric saw to mark and cut the "notch" in a rafter (a standard carpentry task of home construction). In a preliminary study, he observed one of his workers perform this task five times. The observations were made in an air-conditioned, well-lighted training facility, at ground level, with all tools and equipment clean and readily available.
| Observation: | 1 | 2 | 3 | 4 | 5 |
| Task time (seconds): | 82 | 74 | 80 | 83 | 76 |
a. What is the actual average time for this task?
b. What is the normal time for this task if the employee worked at a 20% faster pace than is typical for adequately trained workers?
c. What is standard time for this task if allowances are 8% constant and 6% variable?
d. If the analyst then thought more carefully about his experiment, and decided that the variable allowances needed to be increased to match the real (outside, unair-conditioned) work environment, and that the proper variable allowance was not 6% but 12%, what is the revised standard time?
Time dependence of the rates of a chemical reaction
Various methods for palpation of breast
Results of Tracing Methods
Elementary particles included in the Standard Model
The learning and retention of the mirrordrawing task by H.M. Despite his good retention of the task, ...
The time at which the mailman delivers the mail to Ace Bike Shop follows a normal distribution ...