Picture Gallery

Search For: 

Others

Photo of a sign taken at an emissions test facility.
Views: 411
Filesize: 858.36kB
Date: Jun 1, 2017
 This label on a Toyota Camry hybrid shows the relative smog-producing emissions, but this does not ...
Views: 385
Filesize: 1.65MB
Date: Jun 1, 2017
 The underhood decal showing that this Lexus RX-330 meets both national (Tier 2; BIN 5) and ...
Views: 333
Filesize: 1.41MB
Date: Jun 1, 2017
 Continue the process until the canister is empty and the engine stalls. Remove the cleaning ...
Views: 409
Filesize: 1.35MB
Date: May 31, 2017
Start the vehicle’s engine and let run at 1000–1500 RPM. The engine is now running on fuel ...
Views: 412
Filesize: 1.49MB
Date: May 31, 2017
 Open the outlet valve on the canister.
Views: 305
Filesize: 1.38MB
Date: May 31, 2017
 Canister pressure should be adjusted to 5 PSI below system fuel pressure. An alternative for ...
Views: 415
Filesize: 1.35MB
Date: May 31, 2017
 Connect shop air to the canister and adjust the air pressure regulator to the desired setting. ...
Views: 366
Filesize: 1.16MB
Date: May 31, 2017
Hang the canister from the vehicle’s hood and adjust the air pressure regulator to full OPEN ...
Views: 365
Filesize: 1.23MB
Date: May 31, 2017
 Replace the canister’s top (making sure it is tight) and connect its hose to the fuel rail ...
Views: 361
Filesize: 1.49MB
Date: May 31, 2017
 Pour the injection system cleaning fluid into the open canister. Rubber gloves are highly ...
Views: 336
Filesize: 1.51MB
Date: May 31, 2017
 Remove the fuel injector cleaning canister’s top and regulator assembly. Note that there is an ...
Views: 389
Filesize: 1.47MB
Date: May 31, 2017
Turn the outlet valve of the canister to the OFF or CLOSED position.
Views: 355
Filesize: 1.47MB
Date: May 31, 2017
 The vehicle’s fuel pump is disabled by removing its relay or fuse. In some cases, it may be ...
Views: 363
Filesize: 1.47MB
Date: May 31, 2017
 Start the fuel injector cleaning process by bringing the vehicle’s engine up to operating ...
Views: 435
Filesize: 1.53MB
Date: May 31, 2017
 After testing, be sure to reinstall the relay and the relay cover.
Views: 321
Filesize: 1.33MB
Date: May 31, 2017
Connect a fused jumper wire to supply 12 volts to terminal 86 and a ground to terminal 85 of the ...
Views: 358
Filesize: 1.19MB
Date: May 31, 2017
 To test the normally open contacts, connect one meter lead to terminal 30 and the other lead to ...
Views: 486
Filesize: 1.47MB
Date: May 31, 2017
 Measure between terminal 30 and 87a. Terminal 87a is the normally closed contact, and there should ...
Views: 417
Filesize: 1.4MB
Date: May 31, 2017
 Set the meter to read ohms (V) and measure the resistance of the relay coil. The usual reading for ...
Views: 418
Filesize: 1.45MB
Date: May 31, 2017
Pages: 1 ... 21 22 [23] 24 25 ... 120
Return to Gallery