Picture Gallery

Search For: 

Others

Using a DMM to measure the open-circuit voltage of a battery.
Views: 382
Filesize: 65.72kB
Date: May 30, 2017
 A visual inspection on this battery showed that the electrolyte level was below the plates in all ...
Views: 380
Filesize: 1.76MB
Date: May 30, 2017
 Corrosion on a battery cable could be an indication that the battery is either being overcharged ...
Views: 357
Filesize: 1.67MB
Date: May 30, 2017
 This battery shows a large “1000” on the front panel but this is the CA rating and not the ...
Views: 367
Filesize: 1.05MB
Date: May 30, 2017
Double-check for any oil or vacuum leaks after starting the engine.
Views: 344
Filesize: 1.6MB
Date: May 30, 2017
 Be sure that the clips are properly installed. Start the engine and check for proper operation.
Views: 381
Filesize: 1.5MB
Date: May 30, 2017
 Reconnect all vacuum and air hoses and tubes. Replace any vacuum hoses that are brittle or swollen ...
Views: 353
Filesize: 1.57MB
Date: May 30, 2017
 Reinstall the spark plug wires and all brackets that were removed to gain access to the valve ...
Views: 387
Filesize: 1.62MB
Date: May 30, 2017
Reinstall the distributor cap.
Views: 298
Filesize: 1.56MB
Date: May 30, 2017
 Use a torque wrench and torque the valve cover retaining bolts to factory specifications.
Views: 329
Filesize: 1.54MB
Date: May 30, 2017
 Reinstall the valve cover being careful to not pinch a wire or vacuum hose between the cover and ...
Views: 429
Filesize: 1.57MB
Date: May 30, 2017
 After all valves have been properly measured and adjusted as necessary, start the reassembly process ...
Views: 427
Filesize: 1.55MB
Date: May 30, 2017
Adjusting a valve takes both hands—one to hold the wrench to loosen and tighten the lock nut and ...
Views: 400
Filesize: 1.34MB
Date: May 30, 2017
 The technician is using a feeler gauge that is onethousandth of an inch thinner and another ...
Views: 382
Filesize: 1.39MB
Date: May 30, 2017
 On some engines, it is necessary to watch the direction the rotor is pointing to help determine how ...
Views: 355
Filesize: 1.48MB
Date: May 30, 2017
 The engine is rotated until the timing marks again align indicating that the companion cylinder ...
Views: 335
Filesize: 1.35MB
Date: May 30, 2017
After adjusting the valves that are closed, rotate the engine one full rotation until the engine ...
Views: 361
Filesize: 1.42MB
Date: May 30, 2017
 If the valve clearance (lash) is not correct, loosen the retaining nut and turn the valve adjusting ...
Views: 380
Filesize: 1.23MB
Date: May 30, 2017
 With the rocker arms contacting the base circle of the cam, insert a feeler gauge of the specified ...
Views: 343
Filesize: 1.56MB
Date: May 30, 2017
 The engine is rotated until the timing marks on the front of the crankshaft line up with zero ...
Views: 379
Filesize: 335.5kB
Date: May 30, 2017
Pages: 1 ... 38 39 [40] 41 42 ... 120
Return to Gallery