Question List for "Automotive Technology"

Pages: 1 ... 7 8 [9] 10 11 ... 195
  Topics Views Last post
Skills and Trades » Driveline wind-up on a part-time 4WD system results in all of the listed conditions EXCEPT ________. New
Started by littleanan
 126 Aug 13, 2021
Skills and Trades » When part-time 4WD vehicles in 4WD are engaged in a turn, which of these occur? New
Started by MGLQZ
 149 Aug 13, 2021
Skills and Trades » A customer complained of excessive vibration while cornering and accelerating at the same time. ... New
Started by leilurhhh
 57 Aug 13, 2021
Skills and Trades » Two technicians are discussing the purpose of a transfer case in a four-wheel-drive system. ... New
Started by haleyc112
 213 Aug 13, 2021
Skills and Trades » Where are straight roller bearings used in a rear drive axle? New
Started by Engineer
 1,404 Aug 13, 2021
Skills and Trades » The splines of the drive shaft yoke should be lubricated to prevent ________. New
Started by mrsjacobs44
 44 Aug 13, 2021
Skills and Trades » Technician A says that a proper U-joint inspection can be done with the driveshaft in place on the ... New
Started by aabwk4
 45 Aug 13, 2021
Skills and Trades » Technician A says a final drive ratio is a compromise between performance and vehicle speed. ... New
Started by tichca
 399 Aug 13, 2021
Skills and Trades » FWD driveshaft problems are usually indicated by ________. New
Started by elizabeth18
 90 Aug 13, 2021
Skills and Trades » The most common complaint from CV joint failure is noise while turning. New
Started by azncindy619
 105 Aug 13, 2021
Pages: 1 ... 7 8 [9] 10 11 ... 195