Skills and Trades

Shock absorbers are always mounted vertically, rather than at an angle.

Started by mp14

Multileaf springs are fixed rate springs.

Started by penza

All leaf springs are mounted to the vehicle lengthwise.

Started by Mr3Hunna

Active suspension systems can eliminate body roll while cornering.

Started by Coya19@aol.com

The weight of components not supported by the springs is known as ____________________ weight.

Started by lb_gilbert

Control arms are attached to the frame of the vehicle with ____________________ or polyurethane bushings.

Started by laurencescou

A short-long arm suspension system is also called a(n) ____________________ length arm suspension system.

Started by jake

____________________ suspensions can alter vehicle ride height and shock absorber damping while the ...

Started by K@

____________________ are often described as straightened-out coil springs.

Started by altibaby

Which statement best describes active suspensions?

Started by P68T

Which of the following are included in the sprung weight of a vehicle?

Started by vicky

Which component is the core of any suspension system?

Started by shenderson6

What type of rear suspension is subject to axle tramp, a rapid up-and-down jumping of the rear axle?

Started by crazycityslicker

What ratio of shock absorber is used on most passenger cars?

Started by appyboo

What leaf spring component allows some fore and aft movement to allow for acceleration, ...

Started by Tazate

What is the purpose of a strut rod on some SLA systems?

Started by imanialler

What is the load-carrying member on a regular MacPherson suspension?

Started by maychende

What happens when a wheel hits a dip or hole and moves downward?

Started by vinney12

What is the purpose of a ball joint?

Started by audragclark

Identify three tasks that an independent front wheel suspension system must perform.

Started by sdfghj

Identify some ride characteristics gained from using fibre composite springs.

Started by CBme

Identify four requirements that should be met before checking vehicle ride height.

Started by big1devin

Explain the difference between sprung and unsprung weight.

Started by biggirl4568

When 1.5 mm (2/32 in) is indicated on a tread depth gauge, the tire should be replaced.

Started by brutforce

Radial tires require special patches for puncture repair.

Started by Chloeellawright