Skills and Trades

During a crane lifting operation near energized power lines, it is important to _____. a. use ...

Started by Garrulous

When preparing a job site for excavation or construction, the removal of objects below the original ...

Started by amal

In most jurisdictions, traffic control requires a(n) _____. a. off-duty police officer b. ...

Started by kamilo84

Before a completed building can be used, permanent utilities must be installed and _____. a. the ...

Started by jwb375

The APWA color code used to mark underground gas lines is _____. a. red b. blue c. green d. ...

Started by renzo156

Chipping slag and other coatings from finished welds requires _____. a. written procedures to ...

Started by clippers!

Demolition debris from a construction site _____. a. can be used for fill in the construction ...

Started by Redwolflake15

All SMAW electrodes used for code-governed work must have the AWS classification number printed on ...

Started by TFauchery

B-B Plyform panels are designed for reuse _____. a. 2 to 4 times b. 5 to 10 times c. 16 to 20 ...

Started by xroflmao

The portion of the edge of a part to be joined by a groove weld that has not been beveled or grooved ...

Started by cnetterville

For long-term cutting or welding of materials containing cadmium, wear _____. a. an approved ...

Started by Sportsfan2111

To prevent undercut in a vertical open-root V-groove weld, the welder should _____. a. increase ...

Started by fbq8i

When welding open-root V-groove welds in the horizontal position, do not _____. a. feather tack ...

Started by luminitza

Of the various types of tungsten electrodes available, the tungsten electrodes that are used for AC ...

Started by bobthebuilder

Flat-slab formwork is more costly to build because of the _____. a. need for special shoring b. ...

Started by tth

Titanium becomes sensitive to embrittlement by oxygen, nitrogen, and hydrogen at temperatures above ...

Started by Chelseaamend

Ceriated and lanthanated electrodes are used as non-radioactive substitutes for _____. a. ...

Started by ahriuashd

Before attempting to lower an overhead load, _____. a. put on a back support belt b. shrink wrap ...

Started by LaDunn

What is the proper procedure to lift objects? a. Bend over with your knees straight, feet ...

Started by bobypop

One common way to tie a clove hitch is to use two _____. a. slip knots b. half hitches c. ...

Started by fagboi

To transport a bottle of compressed gas, use a _____. a. hand truck b. cylinder cart c. ...

Started by Alainaaa8

To prevent a tipover when driving a rough terrain forklift, keep the load _____. a. light b. low ...

Started by misspop

What device may have a rotating table surface and/or spikes on the table surface for a better grip? ...

Started by Melani1276

The acronym MPT associated with a fitting means that a _____. a. pipe thread is cut at a medium ...

Started by CQXA

The method used to measure a pipe with a fitting on one end is _____. a. end-to-center b. ...

Started by humphriesbr@me.com