Skills and Trades

One limitation of a single-spring seal is the _____. a. pressure exerted by the spring b. ...

Started by panfilo

Unbalanced seals have a _____ face loading than balanced seals. a. lower b. higher c. lighter ...

Started by futuristic

For maximum energy efficiency in a structure, air infiltration is controlled by properly applying ...

Started by james9437

To meet IRC requirements, the maximum sill height above the floor of an egress window is _____. ...

Started by s.tung

When checking a window opening for squareness, you would use a _____. a. combination square b. ...

Started by clmills979

When you are installing a prehung door, what should be done with the factory-installed spacer shims ...

Started by deesands

In which type of installation would a thermally efficient door most likely be specified? a. A ...

Started by 2125004343

Before installing a door strike, a chisel must be used to cut a _____. a. chamfer b. easement ...

Started by fbq8i

For a lockset installation, professionals generally prefer to use _____. a. a router b. a boring ...

Started by burton19126

Abuse, design deficiencies, material problems, and wear are the four basic causes of machine _____. ...

Started by jace

In order to shoot through a test object and project an image onto a detector or sheet of film, ...

Started by fox

The frequency range for ultrasonic monitoring is from _____. a. 20,000 Hz to 100 kHz b. 20,000 ...

Started by jayhills49

Instead of using time schedules to define equipment repairs and predict failures, PDM uses _____. ...

Started by folubunmi

In eddy current inspection, electrical currents are induced to flow in the test object by a coil of ...

Started by viki

A device that is designed to reach deep inside a machine, magnifies like a microscope, and has its ...

Started by dmcintosh

Infrared radiation is produced naturally by all materials at temperatures above _____. a. ...

Started by geoffrey

In acoustic emission testing, vibrations are detected by a transducer after a machine part has been ...

Started by 123654777

To measure machine wear through lubrication, use lubricant analysis, wear particle analysis, or ...

Started by segrsyd

The start of any PM program involves detailed analysis of past equipment _____. a. developments ...

Started by cookcarl

Tool parts that are worn, broken, or lost should be _____. a. reported to your supervisor b. ...

Started by armygirl

You are standing with your back to the hinge side of the door jamb. The door swings to your left, so ...

Started by ashley

The two major types of doors are _____. a. solid and panel b. flush and wood c. flush and panel ...

Started by evelyn o bentley

To cover a door width of 6, the number of pairs of bifold doors required is _____. a. two b. ...

Started by Alainaaa8

A fire door in a wall leading from living quarters to a garage would be classified on a door ...

Started by rosent76

When a floor will be carpeted, the jamb and casing of an interior wood door should clear the ...

Started by Tazate