Skills and Trades

Two technicians are discussing rear shock absorbers. Technician A says that if one shock is leaking, ...

Started by Collmarie

The left front of the vehicle is higher than the right front and the right rear is lower than the ...

Started by KWilfred

Technician A says that vehicles with independent rear suspensions provide better handling than those ...

Started by asmith134

Technician A says that trailing arms run perpendicular to the center line of the chassis. Technician ...

Started by chads108

Technician A says that trailing arms include any arm where the supported member trails the arm. ...

Started by altibaby

Technician A says that the top mounting nut for a rear shock absorber is often located inside the ...

Started by newbem

Technician A says that suspension diagnosis and service should begin with a comprehensive test ...

Started by sabina

Technician A says that solid rear axles are used only in rear-wheel drive vehicles. Technician B ...

Started by rmenurse

Technician A says that many unit body suspensions use struts on the rear. Technician B says that ...

Started by shenderson6

Technician A says that as axle shafts rotate in one direction to drive the wheels, the axle housing ...

Started by Charlie

Technician A says that a torque arm is designed to support the weight of the vehicle. Technician B ...

Started by savannahhooper

Technician A says that a semi-independent rear suspension is used with live rear axles. Technician B ...

Started by nelaaney

One rear leaf spring is broken. Technician A says that both rear leaf springs should be replaced. ...

Started by roselinechinyere27m

A vehicle equipped with a coil spring front suspension and a leaf spring rear suspension "dog ...

Started by a0266361136

A track rod is also called a ________.

Started by vicky

While servicing a vehicle with modified strut front suspension, technician A makes sure the lower ...

Started by nmorano1

Which of the following is NOT helpful information in diagnosing a suspension problem?

Started by dmcintosh

What should the technician do when replacing stabilizer bar links?

Started by urbanoutfitters

Two technicians are discussing suspension bushings. Technician A says that replacing control arm ...

Started by craiczarry

Two technicians are discussing non-indicator type ball joint inspection. Technician A says that the ...

Started by fahad

To help prevent vehicle wandering on a vehicle with torsion bars, the ride height should be within ...

Started by lak

Technician A says to install press-fit ball joints using a hammer on the ball joint housing to seat ...

Started by cool

Technician A says that when removing pinch bolt connections, turn the nut, not the bolt. Technician ...

Started by ETearle

Technician A says that wear indicator ball joints should be unloaded to check properly. Technician B ...

Started by notis

Technician A says that torsion bars are welded in place and cannot be adjusted. Technician B says ...

Started by Awilson837