Skills and Trades

For the circuit shown, the current flow through R1 is:

Started by krabuske

For the circuit shown, the applied voltage is:

Started by sreghbsidhgjbndskijgnio

For the circuit shown, assuming any one of the resistors is short circuited, the total power would be:

Started by kaitlynndavis

Adding parallel branches to a circuit always:

Started by dhsndn

The total resistance of a series circuit is equal to the sum of the individual load resistances.

Started by agstelzer01

The resistance of a particular load in a series circuit is equal to the voltage across the load ...

Started by poopoo

The current of a series circuit is found by dividing the applied circuit voltage by the total ...

Started by 903f23fj0

Normally the internal resistance of a voltage source is large compared to that of the load and has ...

Started by olgamartinez04

In a series circuit consisting of two different loads, the one with the higher resistance will have ...

Started by caca31

If the applied voltage to a series circuit doubles the resistance will double.

Started by isam

A series circuit has two or more current paths.

Started by isam

With a 240 V source, voltage is divided across three series resistors of 30 V, 40 V, and:

Started by C0DxHalo

Which of the following series combinations dissipates the most power when connected across 100-V DC source?

Started by dekbert

When a third resistor is connected in series with two series resistors, the total resistance:

Started by ncasson210

Three resistors with values of 1 k , 5 k , and 3 k , respectively, are connected in series with a ...

Started by mmmmm

Three resistors (R1, R2, and R3) are connected in series to a 120-V source. The values of E1 and E3 ...

Started by mmmmm

The total resistance of a series circuit:

Started by Emmejo01

The total resistance of a 30 load and 60 load connected in series is:

Started by am7272

Series-aiding voltage sources are connected so that the positive terminal of one voltage source is ...

Started by connormoss

In a series circuit, the amount of voltage each load receives is:

Started by swande

If series resistors dissipate 16 mW, 107 mW, 146 mW, and 243 mW, what is the total power consumed by ...

Started by campbellfam07

If a 24 V and a 6 V battery are series opposing, the total voltage is:

Started by stananza

For the circuit shown, the voltage, VT, would be:

Started by Sadjam2

For the circuit shown, the voltage across R3 would be:

Started by najmarocks25

For the circuit shown, the voltage across R2 would be:

Started by markburs