Physics

Pages: 1 ... 98 99 100 101 102 ... 1132 Go Down

Subject / Started by	Replies / Views	Last post
Assume an n-channel JFET has a VGS(off) of 8 V. If VGS = 4 V, ID will be Started by asmith134	3 Replies 75 Views	Mar 20, 2019 by courtney_bruh
All MOSFETs are subject to damage from electrostatic discharge. Started by tatyanajohnson	1 Replies 74 Views	Mar 20, 2019 by amynguyen1221
Dual-gate MOSFETs can be either depletion or enhancement devices. Started by hbsimmons88	3 Replies 79 Views	Mar 20, 2019 by Kjones0604
The input structure of a MOSFET is a reverse-biased diode. Started by P68T	1 Replies 42 Views	Mar 20, 2019 by lindahyatt42
JFETs and MOSFETs are often referred to as square-law devices. Started by deesands	3 Replies 71 Views	Mar 20, 2019 by Joc
The transconductance curve has the same shape as the transfer curve. Started by clippers!	1 Replies 66 Views	Mar 20, 2019 by ong527
The maximum drain current in a JFET is IDSS, which occurs at VGS = 0 V. Started by mckennatimberlake	3 Replies 103 Views	Mar 20, 2019 by cadimas
For normal operation, the gate-source junction of a JFET is reverse-biased. Started by Charlie	1 Replies 175 Views	Mar 20, 2019 by bbburns21
Refer to Figure 7. The power delivered to the load is Started by Bernana	3 Replies 110 Views	Mar 20, 2019 by xiazhe
Refer to Figure 7. The expected ac emitter voltage for Q1 is Started by washai	1 Replies 76 Views	Mar 20, 2019 by kusterl
Refer to Figure 7. The expected dc emitter voltage for Q1 is Started by deesands	3 Replies 87 Views	Mar 20, 2019 by harveenkau8139
The transistor in a Class-C amplifier is biased for conduction for Started by vicotolentino	1 Replies 49 Views	Mar 20, 2019 by JaynaD87
Refer to Figure 6. The combination of R1, C1, and the base-emitter diode form a Started by Coya19@aol.com	3 Replies 61 Views	Mar 20, 2019 by Andromeda18
Refer to Figure 5. The center tap on the output transformer (marked A) should be connected to Started by 09madisonrousseau09	1 Replies 61 Views	Mar 20, 2019 by anoriega3
Refer to Figure 5. The diode Started by jc611	3 Replies 54 Views	Mar 20, 2019 by durant1234
The amplifier type that frequently has a resonant circuit load is Started by geoffrey	1 Replies 45 Views	Mar 20, 2019 by T4T
The amplifier type that has the worst efficiency is Started by Davideckstein7	3 Replies 57 Views	Mar 20, 2019 by brbarasa
Refer to Figure 4. The amplifier represented is Started by ishan	1 Replies 122 Views	Mar 20, 2019 by chloejackso
A class-A amplifier has an input resistance of 520 and a load resistance of 26 . Assume a 1 Vrms ... Started by LCritchfi	3 Replies 78 Views	Mar 20, 2019 by kswal303
In a class-AB amplifier, the transistors are biased slightly above cutoff to avoid Started by big1devin	1 Replies 53 Views	Mar 20, 2019 by Rilsmarie951
A heat sink is used to Started by DyllonKazuo	3 Replies 64 Views	Mar 20, 2019 by AngeliqueG
Refer to Figure 3. Note the input is a 5 Vrms sine wave. The ac power in RL is ideally Started by notis	1 Replies 74 Views	Mar 20, 2019 by Sammyo
Refer to Figure 3. With no signal in, IC(Q1) is ideally Started by drink	3 Replies 80 Views	Mar 20, 2019 by shayla
Refer to Figure 3. The value of dc bias current in R1 is Started by lb_gilbert	1 Replies 56 Views	Mar 20, 2019 by snackralk
Refer to Figure 3. This type of bias is called Started by deesands	3 Replies 76 Views	Mar 20, 2019 by tranoy

Pages: 1 ... 98 99 100 101 102 ... 1132 Go Up