[Answered] When framing with SIPs, all bottom plates are installed on the subfloor _______

This topic contains a solution. Click here to go to the answer

Author Question: When framing with SIPs, all bottom plates are installed on the subfloor ________ assembly of SIPs ... (Read 151 times)

beccaep

Hero Member
Posts: 535

on: Jul 24, 2018

When framing with SIPs, all bottom plates are installed on the subfloor ________ assembly of SIPs begins.

A) Before B) After C) During

Question 2

How much concrete is required to pour 14 circular piers, 20 in diameter, and 18 deep?

A) .93 cubic yards B) 1.68 cubic yards C) 1.24 cubic yards D) 1.56 cubic yards

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

jessicaduplan

Sr. Member
Posts: 337

Reply #1 on: Jul 24, 2018

Answer to Question 1

A

Answer to Question 2

D

beccaep

Hero Member
Posts: 535

Reply #2 on: Jul 24, 2018

Both answers were spot on, thank you once again

jessicaduplan

Sr. Member
Posts: 337

Reply #3 on: Jul 24, 2018

Great! Please up vote

« previous next »

Did you know?

The average older adult in the United States takes five prescription drugs per day. Half of these drugs contain a sedative. Alcohol should therefore be avoided by most senior citizens because of the dangerous interactions between alcohol and sedatives.

Did you know?

Adults are resistant to the bacterium that causes Botulism. These bacteria thrive in honey – therefore, honey should never be given to infants since their immune systems are not yet resistant.

Did you know?

The heart is located in the center of the chest, with part of it tipped slightly so that it taps against the left side of the chest.

Did you know?

For pediatric patients, intravenous fluids are the most commonly cited products involved in medication errors that are reported to the USP.

Did you know?

Since 1988, the CDC has reported a 99% reduction in bacterial meningitis caused by Haemophilus influenzae, due to the introduction of the vaccine against it.

Top: Autoclave tape before sterilization. Bottom: Autoclave tape after sterilization.

A light shield over an optical sensor being installed before the rotor is attached.

A three-piece filler tube assembly.

Slapping tapotement on the bottom of the foot. Slap lightly 4–5 times.

viable surface sampling using contact plates

Kinetic analysis of spliceosome assembly

Author Question: When framing with SIPs, all bottom plates are installed on the subfloor ________ assembly of SIPs ... (Read 151 times)

Related Topics

Need homework help now?