This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: What is the difference between a relay and a contactor? What will be an ideal ... (Read 92 times)

yoroshambo

  • Hero Member
  • *****
  • Posts: 566
on: Jul 26, 2018
What is the difference between a relay and a contactor?
 
  What will be an ideal response?

Question 2

What is a relay?
 
  What will be an ideal response?


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

kusterl

  • Sr. Member
  • ****
  • Posts: 315
Reply #1 on: Jul 26, 2018
Answer to Question 1

Relays are not connected to the load circuit and are smaller, generally 15

amps or less. Contactors are connected in the load circuit and will need to be larger.

Answer to Question 2

A relay is an electrically operated switch that uses an electromagnet to open or close a set of electrical contacts. Normally only a small amount of current is required to energize the electromagnet. This allows for a device with a high current rating such as an electric heater to be operated by a control relay operated by a low current signal. The control wires can be much smaller and separate from the large main supply lines required for the main load.


yoroshambo

  • Hero Member
  • *****
  • Posts: 566
Reply #2 on: Jul 26, 2018
Both answers were spot on, thank you once again


kusterl

  • Sr. Member
  • ****
  • Posts: 315
Reply #3 on: Jul 26, 2018
Great! Please up vote :D


« previous next »
 

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

About 60% of newborn infants in the United States are jaundiced; that is, they look yellow. Kernicterus is a form of brain damage caused by excessive jaundice. When babies begin to be affected by excessive jaundice and begin to have brain damage, they become excessively lethargic.

Did you know?

Nitroglycerin is used to alleviate various heart-related conditions, and it is also the chief component of dynamite (but mixed in a solid clay base to stabilize it).

Did you know?

All adults should have their cholesterol levels checked once every 5 years. During 2009–2010, 69.4% of Americans age 20 and older reported having their cholesterol checked within the last five years.

Did you know?

Aspirin is the most widely used drug in the world. It has even been recognized as such by the Guinness Book of World Records.

What are examples of ideal forms? What are examples of ideal forms?
The slight (5 microsecond) difference in the firing of the companion cylinders is enough time to ... The slight (5 microsecond) difference in the firing of the companion cylinders is enough time to ...
A typical output driver. In this case, the PCM applies voltage to the fuel pump relay coil to ... A typical output driver. In this case, the PCM applies voltage to the fuel pump relay coil to ...
Hookup for testing fuel-pump current draw on any vehicle equipped with a fuel-pump relay. Hookup for testing fuel-pump current draw on any vehicle equipped with a fuel-pump relay.
Set the meter to read ohms (V) and measure the resistance of the relay coil. The usual reading for ... Set the meter to read ohms (V) and measure the resistance of the relay coil. The usual reading for ...
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Video: The Lac Operon in E. Coli

For a complete list of videos, visit our video library