This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Should pliers be used to tighten or loosen brass fittings? Why or why not? What will be an ideal ... (Read 57 times)

dollx

  • Hero Member
  • *****
  • Posts: 558
on: Jul 26, 2018
Should pliers be used to tighten or loosen brass fittings? Why or why not?
 
  What will be an ideal response?

Question 2

What is the temperature of the water formed when ice melts?
 
  What will be an ideal response?


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

vkodali

  • Sr. Member
  • ****
  • Posts: 357
Reply #1 on: Jul 26, 2018
Answer to Question 1

No because the fitting surface will be damaged.

Answer to Question 2

32F or 0C


dollx

  • Member
  • Posts: 558
Reply 2 on: Jul 26, 2018
Gracias!

nyrave

  • Member
  • Posts: 344
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

According to the National Institute of Environmental Health Sciences, lung disease is the third leading killer in the United States, responsible for one in seven deaths. It is the leading cause of death among infants under the age of one year.

Did you know?

Most women experience menopause in their 50s. However, in 1994, an Italian woman gave birth to a baby boy when she was 61 years old.

Did you know?

It is important to read food labels and choose foods with low cholesterol and saturated trans fat. You should limit saturated fat to no higher than 6% of daily calories.

Did you know?

Since 1988, the CDC has reported a 99% reduction in bacterial meningitis caused by Haemophilus influenzae, due to the introduction of the vaccine against it.

Did you know?

The liver is the only organ that has the ability to regenerate itself after certain types of damage. As much as 25% of the liver can be removed, and it will still regenerate back to its original shape and size. However, the liver cannot regenerate after severe damage caused by alcohol.

Using a torque wrench to tighten connecting rod nuts on an engine. Using a torque wrench to tighten connecting rod nuts on an engine.
Typical slip-joint pliers are common household pliers. The slip joint allows the jaws to be opened ... Typical slip-joint pliers are common household pliers. The slip joint allows the jaws to be opened ...
Needle-nose pliers are used where there is limited access to a wire or pin that needs to be ... Needle-nose pliers are used where there is limited access to a wire or pin that needs to be ...
Adjusting a valve takes both hands—one to hold the wrench to loosen and tighten the lock nut and ... Adjusting a valve takes both hands—one to hold the wrench to loosen and tighten the lock nut and ...
If CP for an ideal gas is 35.4 J/molK, which of the following is CV for this gas? If CP for an ideal gas is 35.4 J/molK, which of the following is CV for this gas?
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Video: Stroke volume

For a complete list of videos, visit our video library