Author Question: A right hand facing tool is used for facing: A) Chucked shafts and large workpieces in chucks B) ... (Read 79 times)

kwoodring

  • Hero Member
  • *****
  • Posts: 560
A right hand facing tool is used for facing:
 
  A) Chucked shafts and large workpieces in chucks
  B) Rough work where a heavy duty facing tool is needed
  C) Centered shaft ends and sharp corners
  D) The face plate

Question 2

The depth of shoulders and steps machined in a workpiece held in a chuck are measured with:
 
  A) Inside micrometer and spring joint caliper B) A hook rule or a depth micrometer
  C) An optical comparator D) Tape measure and spring caliper



jasonq

  • Sr. Member
  • ****
  • Posts: 335
Answer to Question 1

C

Answer to Question 2

B



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
 

Did you know?

Cucumber slices relieve headaches by tightening blood vessels, reducing blood flow to the area, and relieving pressure.

Did you know?

About 60% of newborn infants in the United States are jaundiced; that is, they look yellow. Kernicterus is a form of brain damage caused by excessive jaundice. When babies begin to be affected by excessive jaundice and begin to have brain damage, they become excessively lethargic.

Did you know?

There are 20 feet of blood vessels in each square inch of human skin.

Did you know?

The most dangerous mercury compound, dimethyl mercury, is so toxic that even a few microliters spilled on the skin can cause death. Mercury has been shown to accumulate in higher amounts in the following types of fish than other types: swordfish, shark, mackerel, tilefish, crab, and tuna.

Did you know?

The ratio of hydrogen atoms to oxygen in water (H2O) is 2:1.

For a complete list of videos, visit our video library