Author Question: Parallels are used for: A) Aligning a center punch mark on round stock in vee-blocks B) Scribing ... (Read 53 times)

theo

  • Hero Member
  • *****
  • Posts: 698
Parallels are used for:
 
  A) Aligning a center punch mark on round stock in vee-blocks
  B) Scribing a parallel line along a shaft
  C) Spacing workpieces off the drill press table or vise
  D) Heavy, rough drilling

Question 2

A cutting speed of 80 surface feet per minute is approximately how many cm. per minute?
 
  A) 960 B) 800 C) 38 D) 2438.4



chereeb

  • Sr. Member
  • ****
  • Posts: 326
Answer to Question 1

C

Answer to Question 2

D



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
 

Did you know?

More than 50% of American adults have oral herpes, which is commonly known as "cold sores" or "fever blisters." The herpes virus can be active on the skin surface without showing any signs or causing any symptoms.

Did you know?

There are 20 feet of blood vessels in each square inch of human skin.

Did you know?

Human stomach acid is strong enough to dissolve small pieces of metal such as razor blades or staples.

Did you know?

Interferon was scarce and expensive until 1980, when the interferon gene was inserted into bacteria using recombinant DNA technology, allowing for mass cultivation and purification from bacterial cultures.

Did you know?

Vital signs (blood pressure, temperature, pulse rate, respiration rate) should be taken before any drug administration. Patients should be informed not to use tobacco or caffeine at least 30 minutes before their appointment.

For a complete list of videos, visit our video library