Author Question: Three reasons knurling is done on workpieces are: A) To cover up errors be increasing the ... (Read 45 times)

jCorn1234 · **on:** Jul 26, 2018

Three reasons knurling is done on workpieces are:

A) To cover up errors be increasing the diameter of a part, for tool handles and press fits
B) For tool handles, to resist corrosion and for appearance
C) For press fits, appearance and a gripping surface
D) None of the above

Question 2

Some ways to prevent chatter when cutting off material with a parting tool are to use:

A) A heavy feed, low speed and cut off the material near the chuck or near the tailstock center
B) Coolant, feed in very slowly and use very high speed
C) A light hand feed, low speed that makes a chip, low speed, cutting oil and a rigid setup
D) Diagonally ground parting tools, use heavy power feed and a high speed