Author Question: Centrifugal clutches become positively engaged: A. at no time during operation. B. at high ... (Read 168 times)

kshipps · **on:** Aug 19, 2018

Centrifugal clutches become positively engaged:

A. at no time during operation.
B. at high speeds.
C. at low speeds.
D. during overload.

Question 2

While checking the alignment, you find that the straight edge lines up properly on both
sides of the sheaves and touches at all four points. After rotating one of the sheaves, you
now find hat the straight edge contacts all four points again. Most likely:

A. A shaft is bent.
B. The shafts are not parallel.
C. The driver should be shimmed up.
D. None of the above answers is correct.