« previous next »

Author Question: Most secondary fuel filters should not be prefilled before installation because: a. this will ... (Read 52 times)

azncindy619

  • Hero Member
  • *****
  • Posts: 562
on: Jun 23, 2018
Most secondary fuel filters should not be prefilled before installation because:
 
  a. this will make the system hard to bleed
 b. the primary filter will receive unfiltered fuel c. the injectors will run dry
 d. there will be unfiltered fuel going to the high pressure fuel system

Question 2

If an alternator had a pulley with a 3:1 ratio to the crankshaft and the e engine was turning 1800 RPM then the alternator would be turning at:
 
  a. 300 RPM
 b. 600 RPM
 c. 1800 RPM
 d. 5400 RPM


kaillie

  • Sr. Member
  • ****
  • Posts: 326
Reply #1 on: Jun 23, 2018
Answer to Question 1

D

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

More than 150,000 Americans killed by cardiovascular disease are younger than the age of 65 years.

Did you know?

Many medications that are used to treat infertility are injected subcutaneously. This is easy to do using the anterior abdomen as the site of injection but avoiding the area directly around the belly button.

Did you know?

Oliver Wendell Holmes is credited with introducing the words "anesthesia" and "anesthetic" into the English language in 1846.

Did you know?

Egg cells are about the size of a grain of sand. They are formed inside of a female's ovaries before she is even born.

Did you know?

About 3.2 billion people, nearly half the world population, are at risk for malaria. In 2015, there are about 214 million malaria cases and an estimated 438,000 malaria deaths.

Nanotechnology in Fuel Cell Schematic of a hydrogen gas tank for a car Nanotechnology in Fuel Cell Schematic of a hydrogen gas tank for a car
Detonation is a secondary ignition of the air–fuel mixture. It is also called spark knock or ... Detonation is a secondary ignition of the air–fuel mixture. It is also called spark knock or ...
On some vehicles equipped with an airflow sensor, a switch is used to energize the fuel pump. In ... On some vehicles equipped with an airflow sensor, a switch is used to energize the fuel pump. In ...
A schematic showing that an inertia switch is connected in series between the fuel-pump relay and ... A schematic showing that an inertia switch is connected in series between the fuel-pump relay and ...
Cross section of a typical port fuel-injection nozzle assembly. These injectors are serviced as an ... Cross section of a typical port fuel-injection nozzle assembly. These injectors are serviced as an ...
Secondary Recovery of Oil Secondary Recovery of Oil
Video: Factors that increase metabolic rate and heat production

For a complete list of videos, visit our video library