Author Question: Shell end mills: A) Cut surfaces square to the cutter axis B) Are arbor driven face mills C) Are ... (Read 84 times)

mcmcdaniel · **on:** Jul 26, 2018

Shell end mills:

A) Cut surfaces square to the cutter axis B) Are arbor driven face mills
C) Are small diameter face mills D) All of the above

Question 2

The width of a face-milling cut should be:

A) Less than the diameter of the cutter
B) As wide as the available spindle horsepower allows
C) Equal to the diameter of the cutter
D) In direct proportion to the depth of cut