« previous next »

Author Question: If a 4.7 k, 5.6 k and 10 k resistor are in series, which resistor drops the most voltage? A) the ... (Read 277 times)

j.rubin

  • Hero Member
  • *****
  • Posts: 557
on: Jul 28, 2018
If a 4.7 k, 5.6 k and 10 k resistor are in series, which resistor drops the most voltage?
 
  A) the 5.6 k resistor
  B) the 4.7 k resistor
  C) the 10 k resistor
  D) That can't be determined from the given information.

Question 2

If a 100 , 220 , and 330  resistor are connected in series, total resistance equals ________.
 
  A) less than 100  B) 1650
  C) 650  D) the average of the three values


Zebsrer

  • Sr. Member
  • ****
  • Posts: 284
Reply #1 on: Jul 28, 2018
Answer to Question 1

C

Answer to Question 2

C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Eating carrots will improve your eyesight. Carrots are high in vitamin A (retinol), which is essential for good vision. It can also be found in milk, cheese, egg yolks, and liver.

Did you know?

The first documented use of surgical anesthesia in the United States was in Connecticut in 1844.

Did you know?

It is believed that humans initially contracted crabs from gorillas about 3 million years ago from either sleeping in gorilla nests or eating the apes.

Did you know?

Parkinson's disease is both chronic and progressive. This means that it persists over a long period of time and that its symptoms grow worse over time.

Did you know?

The first war in which wide-scale use of anesthetics occurred was the Civil War, and 80% of all wounds were in the extremities.

A needle that drops to near zero when the engine is accelerated rapidly and then rises slightly to ... A needle that drops to near zero when the engine is accelerated rapidly and then rises slightly to ...
An AC voltage is produced by a magnetic sensor. Most sensors should produce at least 0.1 volt AC ... An AC voltage is produced by a magnetic sensor. Most sensors should produce at least 0.1 volt AC ...
A potentiometer uses a movable contact to vary resistance and send an analog voltage to the PCM. A potentiometer uses a movable contact to vary resistance and send an analog voltage to the PCM.
To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ... To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ...
Instillation of Eye Drops Instillation of Eye Drops
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Video: Enzyme structure - Properties of enzymes

For a complete list of videos, visit our video library