This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: What factors are likely to determine the maximum size part that can be blow molded? What will be ... (Read 101 times)

james9437

  • Hero Member
  • *****
  • Posts: 568
on: Aug 19, 2018
What factors are likely to determine the maximum size part that can be blow molded?
 
  What will be an ideal response?

Question 2

In a blow molded part, where are the thinnest sections likely to occur?
 
  What will be an ideal response?


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

abro1885

  • Sr. Member
  • ****
  • Posts: 337
Reply #1 on: Aug 19, 2018
Answer to Question 1

The parison of the part must be able to be formed without excessive deformation under the weight of the parison itself and must be formed within the time that the resin is still hot. This is determined by the melt strength of the resin, the speed of formation of the parison, and the temperature. Also important are the wall thickness and the blow-up ratio.

Answer to Question 2

The thinnest sections will occur in the areas where the material must move the farthest to fill the mold. The most common location for these thin areas is therefore the corners.


james9437

  • Hero Member
  • *****
  • Posts: 568
Reply #2 on: Aug 19, 2018
TY


abro1885

  • Sr. Member
  • ****
  • Posts: 337
Reply #3 on: Aug 19, 2018
You're welcome


« previous next »
 

Did you know?

An identified risk factor for osteoporosis is the intake of excessive amounts of vitamin A. Dietary intake of approximately double the recommended daily amount of vitamin A, by women, has been shown to reduce bone mineral density and increase the chances for hip fractures compared with women who consumed the recommended daily amount (or less) of vitamin A.

Did you know?

The calories found in one piece of cherry cheesecake could light a 60-watt light bulb for 1.5 hours.

Did you know?

For about 100 years, scientists thought that peptic ulcers were caused by stress, spicy food, and alcohol. Later, researchers added stomach acid to the list of causes and began treating ulcers with antacids. Now it is known that peptic ulcers are predominantly caused by Helicobacter pylori, a spiral-shaped bacterium that normally exist in the stomach.

Did you know?

A recent study has found that following a diet rich in berries may slow down the aging process of the brain. This diet apparently helps to keep dopamine levels much higher than are seen in normal individuals who do not eat berries as a regular part of their diet as they enter their later years.

Did you know?

There are major differences in the metabolism of morphine and the illegal drug heroin. Morphine mostly produces its CNS effects through m-receptors, and at k- and d-receptors. Heroin has a slight affinity for opiate receptors. Most of its actions are due to metabolism to active metabolites (6-acetylmorphine, morphine, and morphine-6-glucuronide).

Chart depicting pupillary size in millimeters Chart depicting pupillary size in millimeters
How to convert verbal statements into algebraic equations (Part 1) How to convert verbal statements into algebraic equations (Part 1)
Use the information in the above table to establish a Born-Haber cycle to determine the ... Use the information in the above table to establish a Born-Haber cycle to determine the ...
Estimating Potential Blood Volume Loss (Part 1) Estimating Potential Blood Volume Loss (Part 1)
Question 37 Part 2 Question 37 Part 2
Relative size ranges and fluorescent dye labeling colors of 16 STR Relative size ranges and fluorescent dye labeling colors of 16 STR
Video: Interview with an Anorexic Woman (Part 2 of 2)

For a complete list of videos, visit our video library