Morgan Clay Products manufactures clay molded pottery on an assembly line. Its standard costing system uses two cost categories, direct materials and conversion costs. Each product must pass through the Molding Department and the Finishing Department. Direct materials are added at the beginning of the production process. Conversion costs are allocated evenly throughout production.
Data for the Assembly Department for August 2017 are:
| Work in process, beginning inventory: | 2600 units |
Direct materials (100% complete)
Conversion costs (35% complete)
| Units started during August | 715 units |
| Work in process, ending inventory: | 520 units |
Direct materials (100% complete)
Conversion costs (55% complete)
Costs for August:
Standard costs for Assembly:
| Direct materials | $18 per unit |
| Conversion costs | $35.50 per unit |
Work in process, beginning inventory:
Which of the following journal entries records the Molding Department's conversion costs for the month, assuming conversion costs are 20% higher than expected?
◦
| Molding Department Conversion Cost Control | 15,414.10 |
Various accounts
15,414.10
◦
| Materials Inventory | 77,070.50 |
| Molding Department Conversion Cost Control | 77,070.50 |
◦
| Molding Department Conversion Cost Control | 92,484.60 |
Various accounts
92,484.60
◦
| Materials Inventory | 92,484.60 |
| Work in Process - Molding | 92,484.60 |
The engine is rotated until the timing marks on the front of the crankshaft line up with zero ...
A typical fuel-pump module assembly, which includes the pickup strainer and fuel pump, as well as ...
Sex Hormone Products
Early Pottery From The Franchthi Cave, Greece
Bright-Line Spectra of Hydrogen and Helium
Nuchal Line