Skills and Trades

When laying out rafters, the distance between the last two may be less than 24, but not more than ...

Started by Cooldude101

When making the birds mouth cut, its depth should not exceed _____. a. one-third the rafters ...

Started by erika

When collar ties are needed to brace rafters, they are installed on _____. a. every rafter b. ...

Started by Davideckstein7

The common difference measurement is used to determine the _____. a. spacing between common ...

Started by karlynnae

The vent opening in a gable end is framed using a header, a sill, and _____. a. trimmers b. king ...

Started by arivle123

Started by berenicecastro

A spreader bar is needed to lift trusses if the span exceeds _____. a. 20 b. 30 c. 40 d. ...

Started by lilldybug07

The space that must be left between panels of roof sheathing to allow for expansion is _____. a. ...

Started by sc00by25

If each common rafter (including tail) of a gable roof is 14 long, how many 16 pieces of lumber will ...

Started by arivle123

When compared to rafters, ridgeboards are typically _____. a. half-again as wide b. one ...

Started by jCorn1234

For personal safety, workers with long hair should _____. a. gather it in a ponytail b. avoid ...

Started by justinmsk

In terms of expense and quality, and starting from the lowest to the highest, cabinets are graded as ...

Started by evelyn o bentley

Started by dejastew

One of the advanced features associated with the GTAW process is the high-frequency intensity ...

Started by ec501234

Which type of fit-up tool is often used to fit flanges and where heavy-duty reforming of the pipe is ...

Started by magmichele12

When installing baseboard molding around the perimeter of a room, outside-corner joints should be ...

Started by leilurhhh

A type of joint made by overlapping two pieces of molding, with one piece having an open miter cut ...

Started by MGLQZ

If shoe molding is being used with a baseboard, the shoe molding should be nailed _____. a. every ...

Started by ts19998

Side casings on doors are normally nailed 1/4 back from the edge of the jamb. This distance is ...

Started by gonzo233

The linear feet of baseboard molding (not including waste) needed to trim a 9' 12' room is _____. ...

Started by natalie2426

Tilt-up construction is not generally cost effective for structures under _____. a. 20,000 square ...

Started by littleanan

Boards used as edge forms for tilt-up panels are commonly _____. a. 1 3 or 1 4 lumber b. 2 3 ...

Started by joesmith1212

The top surface of an insert should be positioned below the concrete panel surface by _____. a. ...

Started by newbem

Skin exposure to concrete or mortar can cause _____. a. silicosis b. scoliosis c. cement ...

Started by washai

Before a panel is tilted up, workers install beam seats and _____. a. panel connectors b. ...

Started by Mr. Wonderful