Physics

Ideally, line regulation is 100%.

Started by fagboi

Refer to Figure 6. If a capacitor is place from CONT to ground it will

Started by nmorano1

Refer to Figure 6. The circuit can be configured as a VCO by applying

Started by strangeaffliction

Refer to Figure 6. The capacitor voltage is between

Started by nautica902

Refer to Figure 6. The output is a

Started by natalie2426

Refer to Figure 5. This is an example of a

Started by RYAN BANYAN

Refer to Figure 5. The output of this circuit is a

Started by yoroshambo

Refer to Figure 4. The output frequency is determined by C1 and

Started by notis

Refer to Figure 4. The two outputs are a

Started by dakota nelson

An Armstrong oscillator

Started by berenicecastro

A simplified oscillator circuit. Refer to Figure 3. If the inductor is changed for one ...

Started by anjilletteb

A simplified oscillator circuit. Refer to Figure 3. The type of oscillator represented is a

Started by a0266361136

A simplified oscillator circuit. Refer to Figure 3. The fraction of the output that is fed back is

Started by javeds

A simplified oscillator circuit. Refer to Figure 3. Assume the circuit is working normally; ...

Started by jessicacav

The overall response of a twin-T feedback network is that of a

Started by BRWH

Refer to Figure 2. Rf determines the

Started by xclash

Refer to Figure 2. The op-amp serves to

Started by bobbysung

Refer to Figure 2. The portion in the dashed box is

Started by neverstopbelieb

Refer to Figure 2. The circuit is

Started by neverstopbelieb

Refer to Figure 1. When adjusted properly the signal at the non-inverting input of the op-amp is

Started by ap345

Refer to Figure 1. The output of the circuit when adjusted properly is a

Started by penguins

Refer to Figure 1. Assume the output signal is 2.0 Vpp. The voltage on the gate of the JFET ...

Started by lunatika

Refer to Figure 1. The JFET acts as a

Started by strangeaffliction

Refer to Figure 1. Assume the frequency of Vout is 6.0 kHz and R1 = R2. The value of each of ...

Started by torybrooks

At startup, a feedback oscillator requires a closed-loop gain of

Started by vicky