Technician A says to install press-fit ball joints using a hammer on the ball joint housing to seat the ball joint in the control arm. Technician B says that a tool resembling a large C-clamp should be used to press ball joints in and out. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
Technician A says that a torque arm is designed to support the weight of the vehicle. Technician B says that a torque arm is designed to prevent rear axle wind up. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Ball and socket joint
Range of Motion of the Temporomandibular Joint, Moving the Jaw From Side to Side
Abduction and adduction of the shoulder joint.
After checking for stored diagnostic trouble codes (DTCs), the wise technician checks service ...
Three types of “end feel” in normal joints.
Palpation for tactile fremitus using metacarpophalangeal joint area