Technician A says to install press-fit ball joints using a hammer on the ball joint housing to seat the ball joint in the control arm. Technician B says that a tool resembling a large C-clamp should be used to press ball joints in and out. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
Technician A says that a torque arm is designed to support the weight of the vehicle. Technician B says that a torque arm is designed to prevent rear axle wind up. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Pivot joint
A typical ball-peen hammer.
This internal bypass passage in the thermostat housing directs cold coolant to the water pump.
Comparison of Joint Mobilizing and Stretching Techniques
Deep friction around the hip joint using the knuckles. Use the knuckle of the middle finger to apply ...
Mobilize joints of the feet and ankle. Apply scissoring to metatarsals and figure-8s to toes. Dorsi- ...