This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which wire on a typical TP sensor should be back-probed to check the voltage signal to the PCM? ... (Read 95 times)

Jkov05

  • Hero Member
  • *****
  • Posts: 556
on: Jun 23, 2018
Which wire on a typical TP sensor should be back-probed to check the voltage signal to the PCM?
 
  A) Signal wire
  B) 5-volt reference (Vref)
  C) Ground wire
  D) Meter should be connected between 5-volt reference and ground.

Question 2

A low O2S voltage could be due to ________.
 
  A) A rich exhaust B) A lean exhaust
  C) A defective spark plug wire D) Both B and C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

Beatricemm

  • Sr. Member
  • ****
  • Posts: 323
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

D


Jkov05

  • Member
  • Posts: 556
Reply 2 on: Jun 23, 2018
Thanks for the timely response, appreciate it

Missbam101

  • Member
  • Posts: 341
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

Though “Krazy Glue” or “Super Glue” has the ability to seal small wounds, it is not recommended for this purpose since it contains many substances that should not enter the body through the skin, and may be harmful.

Did you know?

In 2006, a generic antinausea drug named ondansetron was approved. It is used to stop nausea and vomiting associated with surgery, chemotherapy, and radiation therapy.

Did you know?

Congestive heart failure is a serious disorder that carries a reduced life expectancy. Heart failure is usually a chronic illness, and it may worsen with infection or other physical stressors.

Did you know?

Interferon was scarce and expensive until 1980, when the interferon gene was inserted into bacteria using recombinant DNA technology, allowing for mass cultivation and purification from bacterial cultures.

Did you know?

Eat fiber! A diet high in fiber can help lower cholesterol levels by as much as 10%.

Structure of a typical plant cell Structure of a typical plant cell
An example of the front and back sides of a deposit slip. An example of the front and back sides of a deposit slip.
The primary ignition system is used to trigger and therefore create the secondary (high-voltage) ... The primary ignition system is used to trigger and therefore create the secondary (high-voltage) ...
A typical accelerator pedal position (APP) sensor, showing two different output voltage signals ... A typical accelerator pedal position (APP) sensor, showing two different output voltage signals ...
The relation between a raw EMG signal and its integrated version. The volunteer tensed her muscle ... The relation between a raw EMG signal and its integrated version. The volunteer tensed her muscle ...
Typical bacterial size and structure Typical bacterial size and structure
Video: Homologous chromosomes during prophase I - Animation

For a complete list of videos, visit our video library