This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which wire on a typical TP sensor should be back-probed to check the voltage signal to the PCM? ... (Read 83 times)

Jkov05

  • Hero Member
  • *****
  • Posts: 556
on: Jun 23, 2018
Which wire on a typical TP sensor should be back-probed to check the voltage signal to the PCM?
 
  A) Signal wire
  B) 5-volt reference (Vref)
  C) Ground wire
  D) Meter should be connected between 5-volt reference and ground.

Question 2

A low O2S voltage could be due to ________.
 
  A) A rich exhaust B) A lean exhaust
  C) A defective spark plug wire D) Both B and C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

Beatricemm

  • Sr. Member
  • ****
  • Posts: 323
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

D


Jkov05

  • Member
  • Posts: 556
Reply 2 on: Jun 23, 2018
:D TYSM

nguyenhoanhat

  • Member
  • Posts: 332
Reply 3 on: Yesterday
Wow, this really help

« previous next »
 

Did you know?

About 100 new prescription or over-the-counter drugs come into the U.S. market every year.

Did you know?

The people with the highest levels of LDL are Mexican American males and non-Hispanic black females.

Did you know?

According to the Migraine Research Foundation, migraines are the third most prevalent illness in the world. Women are most affected (18%), followed by children of both sexes (10%), and men (6%).

Did you know?

Liver spots have nothing whatsoever to do with the liver. They are a type of freckles commonly seen in older adults who have been out in the sun without sufficient sunscreen.

Did you know?

The term pharmacology is derived from the Greek words pharmakon("claim, medicine, poison, or remedy") and logos ("study").

A typical office file room. (Paper medical records are rapidly being replaced by electronic ... A typical office file room. (Paper medical records are rapidly being replaced by electronic ...
A typical 12 volt test light. A typical 12 volt test light.
A cutaway of a typical water pump showing the long bearing assembly and the seal. The weep hole is ... A cutaway of a typical water pump showing the long bearing assembly and the seal. The weep hole is ...
Headlights were turned off and the battery voltage quickly recovered to indicate 12.6 volts. Headlights were turned off and the battery voltage quickly recovered to indicate 12.6 volts.
A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ... A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ...
The IAT sensor on this General Motors 3800 V-6 engine is in the air passage duct between the air ... The IAT sensor on this General Motors 3800 V-6 engine is in the air passage duct between the air ...
Video: Mechanism of enzyme action

For a complete list of videos, visit our video library