This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which wire on a typical TP sensor should back-probed to check the voltage signal to the PCM? A) ... (Read 63 times)

EY67

  • Hero Member
  • *****
  • Posts: 531
on: Jun 23, 2018
Which wire on a typical TP sensor should back-probed to check the voltage signal to the PCM?
 
  A) Signal wire
  B) Ground wire
  C) 5-volt reference (Vref)
  D) Meter should be connected between 5-volt reference and ground

Question 2

Which of these sensors does the TP sensor back up if the PCM determines that a failure has occurred?
 
  A) Oxygen sensor B) MAF sensor C) MAP sensor D) Either B or C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

joewallace

  • Sr. Member
  • ****
  • Posts: 337
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

D


EY67

  • Member
  • Posts: 531
Reply 2 on: Jun 23, 2018
YES! Correct, THANKS for helping me on my review

dantucker

  • Member
  • Posts: 346
Reply 3 on: Yesterday
Thanks for the timely response, appreciate it

« previous next »
 

Did you know?

Carbamazepine can interfere with the results of home pregnancy tests. If you are taking carbamazepine, do not try to test for pregnancy at home.

Did you know?

Nearly 31 million adults in America have a total cholesterol level that is more than 240 mg per dL.

Did you know?

Allergies play a major part in the health of children. The most prevalent childhood allergies are milk, egg, soy, wheat, peanuts, tree nuts, and seafood.

Did you know?

In 2012, nearly 24 milliion Americans, aged 12 and older, had abused an illicit drug, according to the National Institute on Drug Abuse (NIDA).

Did you know?

Egg cells are about the size of a grain of sand. They are formed inside of a female's ovaries before she is even born.

A typical joint. A typical joint.
A typical fire extinguisher designed to be used on class A, B, or C fires. A typical fire extinguisher designed to be used on class A, B, or C fires.
A spark tester connected to a spark plug wire or coil output. A typical spark tester will fire only ... A spark tester connected to a spark plug wire or coil output. A typical spark tester will fire only ...
Use palms and fingers to brush off along the back of the body from shoulders to feet with long ... Use palms and fingers to brush off along the back of the body from shoulders to feet with long ...
A flat circular coil having 57 turns of very thin wire has a diameter of 9.5 cm and carries 7.2 ... A flat circular coil having 57 turns of very thin wire has a diameter of 9.5 cm and carries 7.2 ...
How many electrons flow past a given cross section of the wire in 10.3 min? electrons How many electrons flow past a given cross section of the wire in 10.3 min? electrons
Video: Wound Care

For a complete list of videos, visit our video library