This topic contains a solution. Click here to go to the answer

Author Question: Cylinder taper and out of round should be measured ________. A) Just below the ridge B) Near the ... (Read 328 times)

khang

  • Hero Member
  • *****
  • Posts: 569
Cylinder taper and out of round should be measured ________.
 
  A) Just below the ridge B) Near the bottom of piston travel
  C) Both A and B D) Neither A nor B

Question 2

On pushrod engines, camshaft journal diameter often ________ toward the rear of the engine.
 
  A) Increases B) Decreases C) Both A and B D) Neither A nor B



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

Animal_Goddess

  • Sr. Member
  • ****
  • Posts: 339
Answer to Question 1

C

Answer to Question 2

B




khang

  • Member
  • Posts: 569
Reply 2 on: Jun 23, 2018
YES! Correct, THANKS for helping me on my review


Laurenleakan

  • Member
  • Posts: 309
Reply 3 on: Yesterday
Excellent

 

Did you know?

Ether was used widely for surgeries but became less popular because of its flammability and its tendency to cause vomiting. In England, it was quickly replaced by chloroform, but this agent caused many deaths and lost popularity.

Did you know?

Signs and symptoms of a drug overdose include losing consciousness, fever or sweating, breathing problems, abnormal pulse, and changes in skin color.

Did you know?

People with alcoholism are at a much greater risk of malnutrition than are other people and usually exhibit low levels of most vitamins (especially folic acid). This is because alcohol often takes the place of 50% of their daily intake of calories, with little nutritional value contained in it.

Did you know?

The highest suicide rate in the United States is among people ages 65 years and older. Almost 15% of people in this age group commit suicide every year.

Did you know?

Pubic lice (crabs) are usually spread through sexual contact. You cannot catch them by using a public toilet.

For a complete list of videos, visit our video library