This topic contains a solution. Click here to go to the answer

Author Question: Cylinder taper and out of round should be measured ________. A) Just below the ridge B) Near the ... (Read 774 times)

khang

  • Hero Member
  • *****
  • Posts: 569
Cylinder taper and out of round should be measured ________.
 
  A) Just below the ridge B) Near the bottom of piston travel
  C) Both A and B D) Neither A nor B

Question 2

On pushrod engines, camshaft journal diameter often ________ toward the rear of the engine.
 
  A) Increases B) Decreases C) Both A and B D) Neither A nor B



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

Animal_Goddess

  • Sr. Member
  • ****
  • Posts: 339
Answer to Question 1

C

Answer to Question 2

B




khang

  • Member
  • Posts: 569
Reply 2 on: Jun 23, 2018
Thanks for the timely response, appreciate it


elyse44

  • Member
  • Posts: 319
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

 

Did you know?

Asthma cases in Americans are about 75% higher today than they were in 1980.

Did you know?

Cytomegalovirus affects nearly the same amount of newborns every year as Down syndrome.

Did you know?

Parkinson's disease is both chronic and progressive. This means that it persists over a long period of time and that its symptoms grow worse over time.

Did you know?

A good example of polar molecules can be understood when trying to make a cake. If water and oil are required, they will not mix together. If you put them into a measuring cup, the oil will rise to the top while the water remains on the bottom.

Did you know?

An identified risk factor for osteoporosis is the intake of excessive amounts of vitamin A. Dietary intake of approximately double the recommended daily amount of vitamin A, by women, has been shown to reduce bone mineral density and increase the chances for hip fractures compared with women who consumed the recommended daily amount (or less) of vitamin A.

For a complete list of videos, visit our video library