This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: When soldering copper pipe, the wire solder should be touched to the pipe surface once the flux ... (Read 118 times)

mynx

  • Hero Member
  • *****
  • Posts: 555
on: Jul 24, 2018
When soldering copper pipe, the wire solder should be touched to the pipe surface once the flux starts to _____.
 
  A) melt
  B) cool
  C) bubble
  D) harden

Question 2

When using a handheld tube cutter to cut copper tubing, the step performed immediately after making the cut
  is to _____.
 
  A) measure the tubing
  B) remove any burrs from the tubing
  C) bend the tubing to the proper angle
  D) solder the cut end of the tubing


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

skipfourms123

  • Sr. Member
  • ****
  • Posts: 343
Reply #1 on: Jul 24, 2018
Answer to Question 1

Answer: C

Answer to Question 2

Answer: B


mynx

  • Member
  • Posts: 555
Reply 2 on: Jul 24, 2018
Wow, this really help

daiying98

  • Member
  • Posts: 354
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

Cutaneous mucormycosis is a rare fungal infection that has been fatal in at least 29% of cases, and in as many as 83% of cases, depending on the patient's health prior to infection. It has occurred often after natural disasters such as tornados, and early treatment is essential.

Did you know?

Thyroid conditions cause a higher risk of fibromyalgia and chronic fatigue syndrome.

Did you know?

Prostaglandins were first isolated from human semen in Sweden in the 1930s. They were so named because the researcher thought that they came from the prostate gland. In fact, prostaglandins exist and are synthesized in almost every cell of the body.

Did you know?

Lower drug doses for elderly patients should be used first, with titrations of the dose as tolerated to prevent unwanted drug-related pharmacodynamic effects.

Did you know?

Your skin wrinkles if you stay in the bathtub a long time because the outermost layer of skin (which consists of dead keratin) swells when it absorbs water. It is tightly attached to the skin below it, so it compensates for the increased area by wrinkling. This happens to the hands and feet because they have the thickest layer of dead keratin cells.

Heliotropium (marine heliotrope) lower leaf surface, showing trichomes and a few stomata Heliotropium (marine heliotrope) lower leaf surface, showing trichomes and a few stomata
copper copper
The Venusian Surface The Venusian Surface
A magnetic sensor uses a permanent magnet surrounded by a coil of wire. The notches of the ... A magnetic sensor uses a permanent magnet surrounded by a coil of wire. The notches of the ...
Directs surface flow of air Directs surface flow of air
A wave whose wavelength is 0.500 m is traveling down a 500-m long wire whose total mass is 25 ... A wave whose wavelength is 0.500 m is traveling down a 500-m long wire whose total mass is 25 ...
Video: DNA Sequences - Dideoxy Sequencing

For a complete list of videos, visit our video library