« previous next »

Author Question: How is a humidistat similar to a low voltage switch? What will be an ideal ... (Read 16 times)

jman1234

  • Hero Member
  • *****
  • Posts: 560
on: Jul 26, 2018
How is a humidistat similar to a low voltage switch?
 
  What will be an ideal response?

Question 2

The Rankin temperature scale uses the same spacing between degrees as which other system?
 
  What will be an ideal response?


ntsoane kedibone

  • Sr. Member
  • ****
  • Posts: 333
Reply #1 on: Jul 26, 2018
Answer to Question 1

It is very similar to the low voltage thermostat, and it contains both a sensing element and a low voltage electric switch.

Answer to Question 2

Fahrenheit


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Asthma cases in Americans are about 75% higher today than they were in 1980.

Did you know?

Nearly 31 million adults in America have a total cholesterol level that is more than 240 mg per dL.

Did you know?

Acetaminophen (Tylenol) in overdose can seriously damage the liver. It should never be taken by people who use alcohol heavily; it can result in severe liver damage and even a condition requiring a liver transplant.

Did you know?

In ancient Rome, many of the richer people in the population had lead-induced gout. The reason for this is unclear. Lead poisoning has also been linked to madness.

Did you know?

Although not all of the following muscle groups are commonly used, intramuscular injections may be given into the abdominals, biceps, calves, deltoids, gluteals, laterals, pectorals, quadriceps, trapezoids, and triceps.

On some vehicles equipped with an airflow sensor, a switch is used to energize the fuel pump. In ... On some vehicles equipped with an airflow sensor, a switch is used to energize the fuel pump. In ...
A typical accelerator pedal position (APP) sensor, showing two different output voltage signals ... A typical accelerator pedal position (APP) sensor, showing two different output voltage signals ...
To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ... To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ...
Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ... Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ...
How much voltage does the resistor drop in Figure 10-2? How much voltage does the resistor drop in Figure 10-2?
Similar, But Not Related Similar, But Not Related
Video: Introduction to Pre-eclampsia

For a complete list of videos, visit our video library